Step-Up Voltage Regulator U3V40F9 - 9V 3,5A - Pololu 4015

Бестселлер
53916958
1 530 ₽

Мы сотрудничаем с поставщиками электрики Pololu и предлагаем вам самые выгодные предложения на брендовые товары из Америки. Опираясь на свой многолетний опыт, выбираем только лучшие позиции из аутлетов и дискаунтеров, чтобы предоставить вам оптимальные цены, в которые не включены дополнительные расходы на аренду торговых помещений.

Доставка товаров осуществляется прямо с нашего склада до указанного вами адреса. Вы получаете оригинальный товар по цене, которая недоступна для местных магазинов. В нашем интернет-магазине вы всегда найдете широкий ассортимент брендовых товаров с выгодными скидками.

Мы следим за каждым этапом вашей покупки и предоставляем отслеживание заказа на всех этапах, начиная с момента оплаты.

  • Бренд Pololu
  • Доставка из Польши
  • Пункт выдачи СДЭК 9 июня
  • Стоимость доставки заказа в Россию от 689 ₽

Сроки доставки указаны ориентировочно и зависят от региона доставки. Подробнее на этой странице

Характеристики

Выходное напряжение до
9 V

Общие характеристики

Напряжение от
9.0 V
Напряжение до
1.3 V
Выходное напряжение от
9.0 V

Прочие свойства

Бренд
Pololu

Энергопитание

Сила тока
3.5 A
Номинальное выходное напряжение
9 V

Описание

Product description: U3V40F9 - 9V 3,5A step-up converter - Pololu 4015

Pololu brand step-upconverter with an output voltage of 9 V and a capacity of 3.5 A. Supply voltage ranges from 1.3 V to 9 V (starting voltage is 2.7 V). Typical inverter efficiency ranges from 90% to 95%, depending on input voltage and load. The module has temperature protection; it will shut down when the temperature threshold is exceeded.

9 V / 3.5 A step-up converter outputs.
Leads of the step-up converter module

The module has four leads in the form of six holes for soldering connectors with a raster of 2.54 mm.

  • EN - pin which switches off the circuit when the voltage is below 0.4 V, the circuit is switched on by default: 30 kΩ resistor pulled up from EN to VIN.
  • VIN - input voltage from 2.7 V to 9 V (after starting up the chip, the input voltage may be at least 1.3 V).
  • GND - system ground (common for VIN and VOUT).
  • VOUT - output voltage of 9 V.
Hazardous voltage pulses

While connecting the power supply to the module, dangerous, short eclectic impulses with large amplitude (so-called pins) may appear, which can permanently damage the system. Pololu tests show that for input voltages above 11 V pins can have amplitude large enough to damage the module. To protect against this undesirable phenomenon it is recommended to solder a capacitor of at least 33 uF as close as possible to the pins supplying the converter.

System efficiency

Efficiency is defined as the ratio of output power to input power (power out)/(power in). This is a very important parameter when working with portable power sources. (Batteries and rechargeable batteries), where the working time on a single charge cycle matters. The efficiency of this circuit is between 90% and 95%. The output current depends on the input voltage and the system load.

Current efficiency of the U3V40F9 step-up converter.
U3V40F9 9 V / 3.5 A step-up converter. Goldpin connectors included.
U3V40F9 step-up inverter specifications
  • Input voltage: from 1.3 V to 9 V (minimum voltage to run the circuit is 2.7 V)
  • Output voltage: 9 V (with 4% accuracy)
  • Typical efficiency: 90% to 95%, depending on input voltage and load
  • Switching frequency: ~600 Hz at high load
  • Energy-saving mode
  • Typical no-load idle current less than 2 mA
  • 9.5 A switch allows:
    • momentary input current up to 9.5 A
    • up to 4 A input current for a few seconds
    • input current up to 3.5 A for a longer time
  • Integrated protections:
    • shutdown due to excessive temperature
    • soft-start function limits the inrush current and gradually increases the output voltage
    • Output overvoltage protection (typically 16.5 V)
    • input current limitation cycle by cycle to 9.5 A
  • Dimensions: 15.2 x 15.2 x 5.6 mm
  • Weight: 1.5 g
Useful links
  • Manufacturer's website: Pololu #4015
  • Dimensions
  • 3D model

Доставка

Мы доставляем товары напрямую из Германии в Россию курьерской службой или в почтовое отделение. Вы можете выбрать подходящий для вас способ доставки при оформлении заказа. Стоимость доставки зависит от выбранного метода и начинается от 689 руб. Время доставки зависит от выбранного города и метода доставки, но в среднем занимает от 10 до 30 дней. Если вы оформите заказ прямо сейчас, мы доставим его в период с 29 мая - 18 июня.

На протяжении уже более 10 лет мы работаем с надежными и проверенными нами службами и предлагаем доставку электрики Pololu в различные города России, такие как  Москва, Санкт-Петербург, Новосибирск, Екатеринбург, Казань, Нижний Новгород, Челябинск, Самара, Уфа, Ростов, Омск, Красноярск, Воронеж и другие.

Вы всегда можете отследить свой заказ, используя номер посылки, сразу как только он будет отправлен к вам с нашего склада.